| Home | > | Empennage | > | Elevators |
| << Previous | Page 9-4 (50 minutes) | Next >> |
| Step 1. Cleco the E-910 hinge plates onto the aft side of the respective E-1002 front spar webs and final drill the holes indicated. Mark them so you can get them back into their positions correctly.
12/23/06 - 20 minutes |
| Step 2. Final drill the cable routing hole, which will dedicate the E-1002 spars as either left or right. Make these 5/8" in diameter. 12/24/06 - 15 minutes |
 |
 |
Step 3. This is real tough. Cleco the front spars to the skins. Tabs need to be pointing in the right direction. 12/26/06 - 15 minutes |
| << Previous | Page 9-4 | Next >> |
| | | 9-2 | | | 9-3 | | | 9-4 | | | 9-5 | | | 9-6 | | | 9-7 | | | 9-8 | | | 9-9 | | | 9-10 | | | 9-11 | | | 9-12 | | |
| | | 9-13 | | | 9-14 | | | 9-15 | | | 9-16 | | | 9-17 | | | 9-18 | | | 9-19 | | |
| © 2006 Pider-Air |
| Send comments or corrections to the guy in the top left corner |
| jjessen at rcn dot com |